Please share your secrets! What mods have you made to your TRX?
Moderators: trixynut, Mincehead, dicky, phuk72, Jak, Kevtrx849
-
pom in nz
- TRX-Enthusiast
- Posts: 111
- Joined: Mon Jul 21, 2008 11:35 am
- Location: Auckland
Post
by pom in nz » Mon Apr 30, 2012 8:58 am
hey peoples, which jet kit would you recommend to me, dynojet or factorypro.
my bike has custom headers/exhaust system and pod filters, motor is stock as are the carbs, well appart from 150 main jets.
i was thinking of the dynojet stage 3 tdm kit.
and yes i know flat slides are the way to go but i cant afford them
...........................yet
any comments would be most welcome
cheers
You do not have the required permissions to view the files attached to this post.
if its too hard, your doing it wrong.
-
Mincehead
- TRX-Enthusiast
- Posts: 6345
- Joined: Sun Jan 25, 2009 1:40 pm
- Location: West Sussex
Post
by Mincehead » Mon Apr 30, 2012 6:46 pm
Factory pro emulsion tubes (nickel plated) and Yamaha or dynojet needles. The Facyory Pro needles are bitches to set up apparently, although that`s from my time here and what others have posted.
I personally have no direct experience with them as I junked the stock carbs as soon as I could.
LOUD PIPES SAVE LIVES
-
M.V.
- Site Sponsor
- Posts: 1509
- Joined: Sat Jul 04, 2009 3:23 am
- Location: Melbourne, Australia
Post
by M.V. » Tue May 01, 2012 12:19 am
I went with Factory Pro, I had no trouble setting them up, but I did get 2 dyno runs, before & after & made some changes based on the A/F readout, so your mileage might vary...
