FCR41's

[Mincehead]

Ahhh well I was thinking of your own equipment and your `current` situation that was all, no offence implied. A good CNC will knock them out in batches so great if you can get them done, there will always be takers among the FCR converts.

[Kenny]

Take it you have been told lol

[SDN]

I have put a countersunk screw in place of the allen screw and relieved the filler neck a bit with my trusty file and I think I have the clearance. new brass nipples should be here from Venhills, hopefully today. So may be on for dyno run at the weekend - fingers crossed

[Mincehead]

Excellent! I replaced all the fasteners on my FCR`s too, stainless cap screws every time on all my bikes, or if weight is being watched alloy and even titanium too.
Have you got a good dyno service nearby?

[SDN]

Yes do have very local good dyno guy but he is so busy is like getting an appointment with the pope - Craig at Dyno Torque -NWS knows him, there is another place about 10miles away in Cradley Heath that does drive in drive out very reasonable rates - so will give him a go.

Cable nipples should be back from Venhills today so can finish the cables and get the bike running for Dyno run Saturday

Will be good to get the FCR's on and hopefully will be pleased with the result and not lose too much in the way of drivability and fuel consumption

[Kenny]

The one at Cradley Heath is Kev at Projex he is a sound bloke and veru good rates too.