Bar end

boyso20 · Post by **boyso20** » Sun May 06, 2007 6:58 pm

Does anyone have any tips on how to get the original steel ball bar end weight out?
damn things wont budge! grips to tightest setting just slip and scratch them up.

HansJ · Post by **HansJ** » Sun May 06, 2007 8:37 pm

boyso20 wrote:Does anyone have any tips on how to get the original steel ball bar end weight out?
damn things wont budge! grips to tightest setting just slip and scratch them up.

Haven't had a go at them myself, but from other experiences: heat is good for loosening things inside holes... That and some violence...

earywig · Post by **earywig** » Mon May 07, 2007 1:04 pm

Remove the bar from the aluminium clamp on top of the yoke, then use a long piece of steel about ÃƒÆ’Ã‹Å“6mm and thread that through the tapped hole in the opposite end of the bar. Then hammer the end of the rod to remove the aluminium bar end.

CULater · Post by **CULater** » Mon May 07, 2007 10:28 pm

When i replaced the original bar end weights for "LSL Crashball" weights
i used extreme violence, i took a "griptang" clampped the weights and started turning left and right (and pulling outwards), the original weights are sort of "slotted" the weights got damaged in the proces, but what the heck, they look cheap anyway

Griptang

LSL Crashball weights

boyso20 · Post by **boyso20** » Tue May 08, 2007 7:00 pm

i'm using the same grips, just need to be a bit more violent then!
will attack them tonight!

Steelback · Post by **Steelback** » Sun May 13, 2007 9:44 pm

How did you get on, did you get them off

Thinking of doing them on mine.

boyso20 · Post by **boyso20** » Mon May 14, 2007 2:08 pm

job done!

good set of locking grips as in pic and a good twist, turn, shake and a wobble off they come.
be prepared to bin the old bar ends though, as they get knackered in the process.

Steelback · Post by **Steelback** » Fri May 18, 2007 10:33 pm

Will give it a go tomorrow - cheers

Yamaha TRX850 Enthusiasts Forum

Bar end

Bar end

Re: Bar end