Hello!
I just recently got me a TRX - very nice bike.
I bought it in poor running condition. Tore down carbs, cleaned them and put in a new kit with jets and needle etc.
Also replaced a bad coil. Bike runs good now except for a slight hesitation when going from standstill, it feels like i have to get the rpms up a bit before taking off otherwise it almost does not pull at all.
Pilot screws were 2 turns out first, then i tried 3 turns out. Almost no difference.
Any ideas?
Pulls badly from idle
Moderators: trixynut, Mincehead, dicky, phuk72, Jak, Kevtrx849
-
Killerwhale
- Site Sponsor
- Posts: 3797
- Joined: Tue Aug 22, 2006 8:41 am
- Location: GBG/Sweden
- Contact:
Re: Pulls badly from idle
To me it sounds like a standard TRX 
Check gearing and if a 17 in front go 16? Many many do...
Check gearing and if a 17 in front go 16? Many many do...
-
dandywarhol
- Site Sponsor
- Posts: 1639
- Joined: Fri Nov 24, 2006 12:56 pm
- Location: Edinburgh, Scotland
Re: Pulls badly from idle
Did you reset the float height?
1996 TRX 850, blue, Ohlins 46HRCLS, Race Tech Gold Valves, 0.90 springs, Venom pipes, R6 brakes............
1974 Yamaha RD250A, Candy Blue
1998 Yamaha SZR660, blue of course
1967 Yamaha TD1C 250, Blue and white
1974 Yamaha RD250A, Candy Blue
1998 Yamaha SZR660, blue of course
1967 Yamaha TD1C 250, Blue and white
-
pipsovich
- TRX-Enthusiast
- Posts: 28
- Joined: Sun Aug 14, 2016 4:20 pm
Re: Pulls badly from idle
Hehe, not at all impossible as the bike runs great otherwise, and ive never tried any other trx.Killerwhale wrote:To me it sounds like a standard TRX
Check gearing and if a 17 in front go 16? Many many do...
I was thinking about changing the gearing anyways so that might do it!
Float heights were at about 12 mm i think, did not touch these. I will check fuel level with a piece of hose.