Lean
Moderators: trixynut, Mincehead, dicky, phuk72, Jak, Kevtrx849
- Wally
- TRX-Enthusiast
- Posts: 277
- Joined: Fri Oct 07, 2011 8:34 am
- Location: Sydney
- Contact:
Lean
Looking a little lean Yes??
Don't seem to have the guts it did when engine was removed. Only change is cutting 100mm of each can
Also thought I had a bad clutch but have fitted new fibers, steel we're good bead blasted them & refitted but lag still the same
Is this a fuel problem I'm runing out of ideas????
Don't seem to have the guts it did when engine was removed. Only change is cutting 100mm of each can
Also thought I had a bad clutch but have fitted new fibers, steel we're good bead blasted them & refitted but lag still the same
Is this a fuel problem I'm runing out of ideas????
You do not have the required permissions to view the files attached to this post.
- Wally
- TRX-Enthusiast
- Posts: 277
- Joined: Fri Oct 07, 2011 8:34 am
- Location: Sydney
- Contact:
-
- Site Sponsor
- Posts: 6809
- Joined: Thu Aug 28, 2008 9:19 am
- Location: Brisbane,Australia
- Wally
- TRX-Enthusiast
- Posts: 277
- Joined: Fri Oct 07, 2011 8:34 am
- Location: Sydney
- Contact:
Re: Lean
Can't beleave removing a engine painting it on could give me so much trouble when reinstalled
Had to fit replacement stator
Only mod was cut 100mm of each can that was original on the bike
I've had to reset floats to 14mm
17x42 sprockets
Bike had a lot of clutch drag from stand still, had to ride clutch to get going & on a incline was tuff to get going
Replaced fibre clutch plates & no difference fitted a 16 front sprocket this has helped but still ride clutch to start.
Still don't seem to have the up & go it should as before strip Down
The steel plates when I had them out I bead blasted them so I have now removed them to see if slipping I bealeave that I have no slip as no marks of slip on plates as in the pics
More going around in circles I think????????
Had to fit replacement stator
Only mod was cut 100mm of each can that was original on the bike
I've had to reset floats to 14mm
17x42 sprockets
Bike had a lot of clutch drag from stand still, had to ride clutch to get going & on a incline was tuff to get going
Replaced fibre clutch plates & no difference fitted a 16 front sprocket this has helped but still ride clutch to start.
Still don't seem to have the up & go it should as before strip Down
The steel plates when I had them out I bead blasted them so I have now removed them to see if slipping I bealeave that I have no slip as no marks of slip on plates as in the pics
More going around in circles I think????????
You do not have the required permissions to view the files attached to this post.
- Wally
- TRX-Enthusiast
- Posts: 277
- Joined: Fri Oct 07, 2011 8:34 am
- Location: Sydney
- Contact: