Page 1 of 1
Fitting a slipper clutch
Posted: Sat May 04, 2013 11:52 am
by cobbadiggabuddyblooo
Has anyone managed to fit a slipper clutch to there TRX.. I have a Sigma slipper sitting in the box about to go into the motor I'm rebuilding. Neil Spalding from Sigma suggested fitting Barnett R6 plates and springs and I may have to tweak the pushrod.. The slipper is listed to fit a TDM900 TDM / TRX850 YZF750 & 1000 Thundercat
Re: Fitting a slipper clutch
Posted: Sun May 05, 2013 12:41 pm
by cobbadiggabuddyblooo
Wasn't Honk looking at fitting one lookin back on the search???
Re: Fitting a slipper clutch
Posted: Sun May 05, 2013 7:21 pm
by emway
I know that Spondontrx has a sigma slipperclutch on his TRX.
Re: Fitting a slipper clutch
Posted: Mon May 06, 2013 7:38 am
by cobbadiggabuddyblooo
Cheers for that, I knew I'd read somewhere someone had done this so sent a PM. Got an idea his may be a 900 motor but good to find out any info about plates and spring choice