Page 1 of 1
Gilles Chain Adjusters
Posted: Mon Oct 30, 2006 10:36 am
by Wombat
Has anyone seen these? Pure Bling! Of course they don't list any for the TRX. But I was thinking, would ones for say an early R6 fit? Are the dimensions of the axle cutout in the swingarm the same? From memory the dimensions are 45mm high, 88mm length and 24 - 25mm across the flat faces of the axle spindle end. Anyone know anyone that has an early R6 and could measure it?
Bob
Re: Gilles Chain Adjusters
Posted: Mon Oct 30, 2006 5:23 pm
by burty
Wombat wrote:From memory the dimensions are 45mm high, 88mm length and 24 - 25mm across the flat faces of the axle spindle end.
I can't help, but I am curious as to how you happen to know this kind've information.
Posted: Tue Oct 31, 2006 5:30 am
by Wombat
Vernier calipers, Burty, of course
Bob
Posted: Tue Oct 31, 2006 11:27 am
by burty
I wasn't referring to the method of measurement actually, but the fact that you had measured them and committed it to memory.
Unless of course you had only recently measured them of course.
