https://m.youtube.com/watch?v=QA8g89oXyZY
How to change the polarity on the pins with your TPS .
A must if running TDMR carbies due to the TPS mounted on the opposite side.
Polarity change on TPS when running TDMR 40
Moderators: trixynut, Mincehead, dicky, phuk72, Jak, Kevtrx849
3 posts
• Page 1 of 1
Polarity change on TPS when running TDMR 40
by cobbadiggabuddyblooo » Sun Nov 11, 2018 1:46 pm
laughter is the best medicine
- cobbadiggabuddyblooo
- Site Sponsor
- Posts: 6809
- Joined: Thu Aug 28, 2008 9:19 am
- Location: Brisbane,Australia
Re: Polarity change on TPS when running TDMR 40
by PrfctChaos » Mon Nov 12, 2018 12:18 am
Im not sure the TPS does too much. I run a set of TDMR carbies and one of the ignitech ignitions. No TPS and runs just fine.
From memory I think with a TPS enable there is only a change in the timing sub 20 or 30% throttle opening. But I think my bike behaves well at small throttle opening, with TPS disabled.
From memory I think with a TPS enable there is only a change in the timing sub 20 or 30% throttle opening. But I think my bike behaves well at small throttle opening, with TPS disabled.
1996 TRX, Front end from a 2006 GSXR 750, Seat off a 2012 Triumph street triple. TDMR carbs, Laser cans, Perreli Rosso Supercorsas.
-
PrfctChaos - TRX-Enthusiast
- Posts: 73
- Joined: Wed Nov 06, 2013 2:54 am
- Location: Perth, Australia
Re: Polarity change on TPS when running TDMR 40
by cobbadiggabuddyblooo » Mon Dec 02, 2019 8:30 am
Here you go David in case the link doesn’t work...
laughter is the best medicine
- cobbadiggabuddyblooo
- Site Sponsor
- Posts: 6809
- Joined: Thu Aug 28, 2008 9:19 am
- Location: Brisbane,Australia
3 posts
• Page 1 of 1
Return to TRX Mods and Upgrades
Who is online
Users browsing this forum: No registered users and 2 guests