https://m.youtube.com/watch?v=QA8g89oXyZY
How to change the polarity on the pins with your TPS .
A must if running TDMR carbies due to the TPS mounted on the opposite side.
Polarity change on TPS when running TDMR 40
Moderators: trixynut, Mincehead, dicky, phuk72, Jak, Kevtrx849
-
- Site Sponsor
- Posts: 6809
- Joined: Thu Aug 28, 2008 9:19 am
- Location: Brisbane,Australia
Polarity change on TPS when running TDMR 40
laughter is the best medicine
- PrfctChaos
- TRX-Enthusiast
- Posts: 73
- Joined: Wed Nov 06, 2013 2:54 am
- Location: Perth, Australia
Re: Polarity change on TPS when running TDMR 40
Im not sure the TPS does too much. I run a set of TDMR carbies and one of the ignitech ignitions. No TPS and runs just fine.
From memory I think with a TPS enable there is only a change in the timing sub 20 or 30% throttle opening. But I think my bike behaves well at small throttle opening, with TPS disabled.
From memory I think with a TPS enable there is only a change in the timing sub 20 or 30% throttle opening. But I think my bike behaves well at small throttle opening, with TPS disabled.
1996 TRX, Front end from a 2006 GSXR 750, Seat off a 2012 Triumph street triple. TDMR carbs, Laser cans, Perreli Rosso Supercorsas.
-
- Site Sponsor
- Posts: 6809
- Joined: Thu Aug 28, 2008 9:19 am
- Location: Brisbane,Australia
Re: Polarity change on TPS when running TDMR 40
Here you go David in case the link doesn’t work...
laughter is the best medicine