After recently being tipped over by a car driver at a stop sign, which damaged the left front indicator, I decided to replace them all with Led indicators.
This required a new support on the inside of the fairing, I decided to make it from 3d printed ABS. After designing it with Tinkercad, I had several test pieces made at the local library. As they could not print them in black, I had them printed locally using a 3d hub printer.
This design is now available for anyone to download and use on Thingiverse, just look under Yamaha TRX850.
I made up an aluminium plate to fit between the faring and the indicator, 3mm thick.
The indicator has a 10mm diam post.
These indicators were purchased via Aliexpress, they did not require a new flasher unit, work fine off the oem unit.
Led indicator base, 3d printed
Moderators: trixynut, Mincehead, dicky, phuk72, Jak, Kevtrx849
- OzzieDave
- TRX-Enthusiast
- Posts: 91
- Joined: Sun Oct 02, 2016 11:33 pm
- Location: Woodcroft, South Australia
Led indicator base, 3d printed
Proudly Aspergian. Yellow 98 TRX850, Staintune mufflers, braided brake hoses, blue spot brakes, remote control ignition switch, Ignitech ECU. 17/42 525 chain.
- wreckage
- Site Sponsor
- Posts: 372
- Joined: Sat Sep 27, 2014 4:59 am
- Location: Brisbane, Australia
Re: Led indicator base, 3d printed
Wherever you go, there you are.