cheap carb upgrade?

[baptie0]

Today I ordered a 44idf carburettor from China for my trx!

http://g04.a.alicdn.com/kf/HTB1crunLXXX ... m-font.jpg

[dandywarhol]

Nice one - if it's anything like the carbs on cheapo Chinese bikes it'll be absolute shite - look good on a Chinese V8 Xialong XL2060L

[Rod.s]

Today I ordered a 44idf carburettor from China for my trx!

http://g04.a.alicdn.com/kf/HTB1crunLXXX ... m-font.jpg

Why?

[boggy1995]

April fool?

[baptie0]

I'm going to make a manifold and fit it to my bike...cheap power

[Rod.s]

I'm going to make a manifold and fit it to my bike...cheap power

No such thing, with an untried carburettor, custom manifolds, and these have many jets etc. But then again i need a laugh

[dandywarhol]

I thought you were having a laff baptie - I look froward to the before and after dyno results.

Here's your nearest shop http://www.hmdtuning.co.uk/

[baptie0]

Nah I'm serious, the carb type I'm using is very tunable and they have been used on many boxer type car engines, eg vw Porsche and Alfa romeo..

[baptie0]

I had fcr41s in the past but sold them, my own carbs are worn massively, this is a cheap, tunable down draught carburettor, just need to make a manifold

[Mincehead]

Go for it, I would love to see it work on the cheap for you.

[dandywarhol]

I used to do a bit of work on downdraft Porsche carbs.
They were genuine Weber or DellOrto.
Problem with Chinese copies can be porosity of the castings, lot of Chinese mini bikes suffer from that

[Mincehead]

Just go full Porsche eh?

http://www.ebay.co.uk/itm/Downdraft-Car ... SwyZ5Uqq7X

[dandywarhol]

4mm too small

[Mincehead]

3mm drill through the jets, that`ll sort it.

[baptie0]

Hopefully I've not spent 115 quid on a table ornament... I nearly opted for a 40mm IDF clone Mince, but after a bit of digging about decided on a 44mm one, should be here this week!