Yamaha TRX850 Enthusiasts Forum

Been meaning to post this for a while now, but being a ludite and relying on mates to drag me into the 21st century, caused some delays.

The main reason for posting is to give huge thanks to dixonj and tzx660 without whose efforts i would still have a dancing chain.

Not only did they source and design the sprocket but got mine machined up for me at their machinist.

I asked a mate to photograph the new sprocket and chain alignment and clearance achieved between chain and swing arm. I dont know how successful the pics are but chain is straight and lines up with the guide.

Your are more than welcome Andy.

It's such a relief to know that my chain isn't nibbling away at the swing arm, the rear sprocket restored to proper fitment, clearance everywhere and a straight chain.

Cheers, Andy.

That's great service , I think I will probably need one for my YZF arm conversion ? How do I get hold of one ? Thanks Steve.

You'd have to speak to either of the fine gentlemen from up north for precise details.

It's a special offset socket from a supplier that is then further modified.

Cheers, Andy.

Bucko's order is on the way. )

An offset sprocket at either end of the A470.

Will have to meet in the middle when bike is not sorned.

Cheers, Andy.

DixonJ has just done one for me , I have to say it was top service and speedily done , recommended. I will post a photo when the bikes back together which will hopefully be soon.

Bucko wrote:DixonJ has just done one for me , I have to say it was top service and speedily done , recommended. I will post a photo when the bikes back together which will hopefully be soon.

Enjoy