Yamaha TRX850 Enthusiasts Forum

phuk72 wrote:

Strix wrote:What length of dogbones would give 15-20 mm raise at the rear? Can you do them?

Lowered 20 mm, as in measured from the top or 20 mm more (lower) than original?

That's prety much teh effect YZF dogbones have

Well, the YZF dogbones give around a 35mm lift, so I suppose the effect on the attitude of the bike is similar, however, by using +20 on the back and -20 on the front you're keeping the overall height of the bike standard-ish instead of raising the whole shebang by up to 35mm.

Strix- 179mm dogbones will give around 12mm lift and 173mm will give around 31mm. I can make some lengths up in between (176-177mm) if you like.

Kayla wrote:

phuk72 wrote:

Strix wrote:What length of dogbones would give 15-20 mm raise at the rear? Can you do them?

Lowered 20 mm, as in measured from the top or 20 mm more (lower) than original?

That's prety much teh effect YZF dogbones have

Well, the YZF dogbones give around a 35mm lift, so I suppose the effect on the attitude of the bike is similar, however, by using +20 on the back and -20 on the front you're keeping the overall height of the bike standard-ish instead of raising the whole shebang by up to 35mm.

Strix- 179mm dogbones will give around 12mm lift and 173mm will give around 31mm. I can make some lengths up in between (176-177mm) if you like.

Phuk72, what Kayla said so -->

As mentioned - I have already tried the YZF ones and it was about 30-35 mm lift. Too much.
Sounds like we have hit the sweetspot Kayla - yep Im in for a pair of those.

PM me for payment and so on.

Thanks.