cylinder head

General Discussion Forum for TRX Enthusiasts...

Moderators: trixynut, Mincehead, dicky, phuk72, Jak, Kevtrx849

Post Reply
markymark
TRX-Enthusiast
Posts: 24
Joined: Sun Jun 23, 2013 8:05 pm

cylinder head

Post by markymark » Wed Sep 30, 2020 9:59 pm

hi all,
does any one have a cylinder head for sale.
and can any one tell me if the trx head is the same as the tdm.

User avatar
Tarwetijger
TRX-Enthusiast
Posts: 1537
Joined: Tue May 15, 2007 9:31 am
Location: Netherlands, Assen
Contact:

Re: cylinder head

Post by Tarwetijger » Thu Oct 01, 2020 9:02 am

markymark wrote: does any one have a cylinder head for sale.
and can any one tell me if the trx head is the same as the tdm.
4TX: yes
3VD: no (at least the cams are different)
900: no

User avatar
Snod Blatter
TRX-Enthusiast
Posts: 405
Joined: Sun Sep 16, 2012 8:40 am
Location: Worksop, UK

Re: cylinder head

Post by Snod Blatter » Fri Oct 02, 2020 2:15 pm

Whereabouts are you markymark? I have the original head (and cams) from my 4NX sitting in a bag on the garage floor, some inlet valves are well sunk (the reason I changed it) and it'll need some shims for the clearances because I nicked a few to make the replacement head right but if you're nearby you can have it if you want. Oh and the inlet rubbers are all cracked up..
'95 4NX with K&N filter, Motad Venom cans, YSS PD valves, Ohlins fork springs, 530 C+S, Green CDI, 11/16 radial master cylinder, +30mm jack up dog bones. Enjoyable money pit.

markymark
TRX-Enthusiast
Posts: 24
Joined: Sun Jun 23, 2013 8:05 pm

Re: cylinder head

Post by markymark » Tue Oct 06, 2020 7:52 pm

did you get my pm message

User avatar
Snod Blatter
TRX-Enthusiast
Posts: 405
Joined: Sun Sep 16, 2012 8:40 am
Location: Worksop, UK

Re: cylinder head

Post by Snod Blatter » Wed Oct 07, 2020 1:15 pm

Nope..?
'95 4NX with K&N filter, Motad Venom cans, YSS PD valves, Ohlins fork springs, 530 C+S, Green CDI, 11/16 radial master cylinder, +30mm jack up dog bones. Enjoyable money pit.

markymark
TRX-Enthusiast
Posts: 24
Joined: Sun Jun 23, 2013 8:05 pm

Re: cylinder head

Post by markymark » Wed Oct 07, 2020 5:57 pm

hi ,i have sent a few pm`s
i would like to take you up on your offer for the cyliner head.
can i put my email on here.
many thanks..........

markymark
TRX-Enthusiast
Posts: 24
Joined: Sun Jun 23, 2013 8:05 pm

Re: cylinder head

Post by markymark » Thu Oct 08, 2020 3:01 pm

snod blatter please can you reply if you read this message.........

Post Reply