Yamaha TRX850 Enthusiasts Forum

After 15 years of my trx wearing an "over racing" full fairing I have recently gone back to the original factory look. (might sell the full fairing. not sure yet.)
Id like to put a belly pan on the bike but I'm not sure what to go with. Does anyone know which pan will fit with "over" headers?

cheers
bane.

I got one of the belly pans from "The Simple"

http://www.the-simple.info/

I ordered it from J-parts

http://www.j-mart.biz/j-parts/index.php ... cts_id=122

Excellent service. Was made to order and arrived from Japan in about a week.

This is it on the bike


more pictures here:
viewtopic.php?f=6&t=7414&start=165

Thanks for that Paul. My bike is black also so it gives me a good i idea of how it would look on my bike. Is that standard headers on yours? The pipes look like they are very close to the pan so I dont think it would fit with the over headers.

bane.

ah, sorry missed this,

It is a close fit with the stock pipes so adjustment would be needed.........no sure the you would have sufficient space even with adjustment

I'm sure Cobba will chime in on the brand of this one! looks great, fits well, BUT the rear bolt need to be recessed as it hits on speed bumps

When fitted


After a large speed bump!!!!

I have an idea Victor may have said that it was a Harris ...
I know it doesnt fit with an Akrapovic system tho.

Power bronze belly pan for me.

I think of gone off the idea of a belly pan in favour of blacking out the engine. Would still be good to know which belly pan fits with the over pipes though. Does anyone know about the power bronze?

Bane.

Rod.s wrote:I'm sure Cobba will chime in on the brand of this one! looks great, fits well, BUT the rear bolt need to be recessed as it hits on speed bumps

When fitted


After a large speed bump!!!!

Hi,
I have the Same belly pan lying waiting to be fittet and came around your Post.
My question is: have you shortend the holder where the red arrows Point to for more ground clearence?

I've fitted a Harris no problems with a 2-1 projection exhaust.

I now have a projection components system with my "The Simple" belly pan.

I needed to make a longer bracket for the supported piece at the back. Fine on the front, but very close to the exhaust, i used some heat shielding material

Ragnar wrote:

Rod.s wrote:I'm sure Cobba will chime in on the brand of this one! looks great, fits well, BUT the rear bolt need to be recessed as it hits on speed bumps

When fitted


After a large speed bump!!!!

Hi,
I have the Same belly pan lying waiting to be fittet and came around your Post.
My question is: have you shortend the holder where the red arrows Point to for more ground clearence?

I haven't done anything as of yet, but I have a plan! I was just going to recess/countersink the hole and use a countersunk "Allen key" bolt so that is sits flush with the underside.

Why not a screw??

cobbadiggabuddyblooo wrote:Why not a screw??

because of the length...only need the thread on the last 2cm