Yamaha TRX850 Enthusiasts Forum

Errr yeah. The threaded holes at the rear of the swingarm - just perfect for clipping the race stand onto if I could get some bolts that fit. The thread is 10mm, but the pitch???? Standard pitch for M10 seems to be 1.5mm, which is too coarse. I need what? 1.25 or 1.0mm? Anyone know?

It`ll `likely` be standard metric fine Dave M10 x 1.25.
You might find this useful(and anyone else for that matter):

http://homepages.tesco.net/~A10bsa/isofgo.htm

M10 x 1.0 does exist but it`s pretty uncommon.
Here`s some listings for the less usual fine pitches anyway:

http://stigfasteners.easywebstore.co.uk ... B22PT.aspx

Yep, 1.25mm pitch it is thanks Mincehead. Grabbed a couple from the local bolt bloke and they're perfect.

Couple of nylon bosses or turned aluminium and your away then Dave.
Skateboard wheels can be turned down too,they also make cheap crash bungs.

....or go dodgy.....two washers and a 10mm long spacer. I must get something to replace that lot.

Dodgy???? No way, this is a... how you say... "proper job".

Now if I could only find a decent throttle lock / cruise control...

davamb wrote:Now if I could only find a decent throttle lock / cruise control...

Are these rubbish ?
http://cgi.ebay.co.uk/ws/eBayISAPI.dll? ... 0158913136
I just bought one, seems ok.

I bought one but I haven't made my mind up yet. Couldn't get my hand to sit right, but maybe a different pair of gloves could work better. Haven't used it for a little while now.

davamb wrote:Dodgy???? No way, this is a... how you say... "proper job".

Now if I could only find a decent throttle lock / cruise control...

That's all they do in the work shop if you haven't got bobbins on already.