Page 1 of 1

starter circuit cut off relay

Posted: Wed Nov 14, 2007 12:57 pm
by mickjmag
Hi All
Have thrown this post up once before, but I'm in the hunt for a starter circuit cutoff relay. Part No: 4EP-81950-00
G8R-30Y-F
Without this item the bike sucks!!!!!!!!
Basically what happens is you have to hot wire the bike so that it runs, but you can't run the bike with the side stand down and you have no neutral light.
Have exhausted all the wreckers and yamaha want $110 aussie paesso's
for one so if anyone knows where the freakin hell I can get such a simple but hard to find part, PLEEEEZE let me know!!


Cheers, Mick

Re: starter circuit cut off relay

Posted: Wed Nov 14, 2007 1:39 pm
by Killerwhale
mickjmag wrote:Hi All
Have thrown this post up once before, but I'm in the hunt for a starter circuit cutoff relay. Part No: 4EP-81950-00
G8R-30Y-F
Without this item the bike sucks!!!!!!!!
Basically what happens is you have to hot wire the bike so that it runs, but you can't run the bike with the side stand down and you have no neutral light.
Have exhausted all the wreckers and yamaha want $110 aussie paesso's
for one so if anyone knows where the freakin hell I can get such a simple but hard to find part, PLEEEEZE let me know!!


Cheers, Mick
Look at the "TPS mod", there it shows how to eliminate side stand switch at least...
I have the problem other way around i CAN drive with sidestand down...wich has gone so so a couple of times...

Posted: Wed Nov 14, 2007 2:21 pm
by youngy
http://cgi.ebay.co.uk/YAMAHA-TRX-850-20 ... dZViewItem

is it one of these 2?



http://www.mwbbikewreckers.com.au/ these guys have some stuff on Ebay - says they have a complete bike

Posted: Wed Nov 14, 2007 2:28 pm
by youngy

Posted: Wed Nov 14, 2007 2:29 pm
by youngy
http://cgi.ebay.co.uk/FAISCEAU-ELECTRIQ ... dZViewItem

or is it on here?


you could also try this fella - he has most things TRX and TDM available:

http://www.gn-moto.com/

Posted: Wed Nov 14, 2007 10:17 pm
by slow codger
:? Just a thought, know a competent TV / Video electrical engineer, who could probably make one up for a lot less than Yamaha, depends on any chips on the board.

Dave e