Part No for the f**king bolts to the valve cover?

[jpe]

While not by far as bad as KW's trouble or HansJ's my season doesn't look to be a good one. After fixing a leaking valve cover gasket twice without luck I went at it in good mood for the third time tonight. All's good and the new gasket fits like a glove. Starting to use my torque wrench after fitting the bolts by hand and "knick" one of the bolts says goodbye...

Obvious cause is fatigue, it didn't snap off but just gave in. And I didn't even get to the stipulated 10 Nm 's on the wrench

So, here I am. In desperate need of a bike for the weekend and coming courses but in just as desperate lack of time to continue this stupid mindgame with the bike.

Coming to the end of my rantings, anyone has the parts no for those bolts holding the valve cover? Those flange head bolts holding the camshafts too?
Ordering from the local dealer is just as likely to ruin me...

[Killerwhale]

Have a look at page 26 in the service manual here on the site, i THINK i saw what you where after there!?
Camshaft cap bolt where in there so.....

Yes, and my problem.....it´s just insane!
WILL book hotel for the thunderday bike or not....i´m a descent photographer so if not racing i can take frames of the event!

Hope i´m right about the page.....

While not by far as bad as KW's trouble or HansJ's my season doesn't look to be a good one. After fixing a leaking valve cover gasket twice without luck I went at it in good mood for the third time tonight. All's good and the new gasket fits like a glove. Starting to use my torque wrench after fitting the bolts by hand and "knick" one of the bolts says goodbye...

Obvious cause is fatigue, it didn't snap off but just gave in. And I didn't even get to the stipulated 10 Nm 's on the wrench

So, here I am. In desperate need of a bike for the weekend and coming courses but in just as desperate lack of time to continue this stupid mindgame with the bike.

Coming to the end of my rantings, anyone has the parts no for those bolts holding the valve cover? Those flange head bolts holding the camshafts too?
Ordering from the local dealer is just as likely to ruin me...

[jpe]

Hope i´m right about the page.....

Nope, sorry. Page only has a torque spec and bolt count. Doesn't even state length. (got the manual printed and taking up space in the garage...)

[Killerwhale]

Hope i´m right about the page.....

Nope, sorry. Page only has a torque spec and bolt count. Doesn't even state length. (got the manual printed and taking up space in the garage...)

If i find anything i´ll post asap!