Dynatec coils , mud map
Posted: Thu Oct 17, 2019 8:42 am
Gents , I need a diagram and or feedback on how to connect up a set of dyna coils with relay . Where i'am at so far , i've connected the Power wire from the relay to the (+) on both coils . Grey wire to the ( - ) left coil , Orange wire to the ( - ) right coil , I'm pretty sure these 2 go to the ECU . Connect an earth wire to right coil mounting bracket . Use 1 of old the power feed wires to activate relay . ( Can i use the either of the old coil power feed wires to the relay as the activator ?) Relay power with fuse to the switchy block thing where the battey postive lead goes to , and relay earth to seat latch bracket . I sounds simple but because i've done all the seals in the carbies as well and the bike is not starting i thought i'd start with the coils first for problem shooting and work up from there . Thanks boys .