Setting float levels ... to which float half?
Posted: Sat Apr 11, 2015 7:09 am
.
I did a search and didn't really find much to answer my question....
Unfortunately, the digital copy of my TRX Workshop Manual only goes as far as Chapter 9.
Apparently Chapter 10 is where float levels are explained. Wouldn't you know it?
I've done 'em plenty of times on old TZs back in the day, so I'm fairly familiar with the (fiddly bloody! ....) process .....
It's just that the float halves in my 1998 TRX carbs are different sizes. ie. in each carby each float half is a different size, one half hangs about 2mm lower than the other when the carbs are held upright.
Which float do I make my measurements to? The lower hanging one, or the higher one?
I'm guessing the lower one.
Yeah?
I did a search and didn't really find much to answer my question....
Unfortunately, the digital copy of my TRX Workshop Manual only goes as far as Chapter 9.
Apparently Chapter 10 is where float levels are explained. Wouldn't you know it?
I've done 'em plenty of times on old TZs back in the day, so I'm fairly familiar with the (fiddly bloody! ....) process .....
It's just that the float halves in my 1998 TRX carbs are different sizes. ie. in each carby each float half is a different size, one half hangs about 2mm lower than the other when the carbs are held upright.
Which float do I make my measurements to? The lower hanging one, or the higher one?
I'm guessing the lower one.
Yeah?